Update the firmware of Hantek2D72/2D42/2C72/2C42

Alan_C · Post time 2019-2-26 01:57:01

Hi
I have just updated to the latest firmware, I have 2 issues that are bothering me

1, Why is the Autoranging on DMM, OHM of this multimeter is so SLOW ??
2, would greate if the backlight timeout would reset itself when the meter is being used on DMM ( when input is detected )

Is it possible to resolve these issues?

Thanks

Alan_C · Post time 2019-2-26 02:21:44

Hi
I have a new problem after upgrading the firmware I lost the AWG function meter is being detected as 2C42 !! when it should be 2D42

How can I resolve this Please help

Alan_C · Post time 2019-2-26 16:15:31

Edited by Alan_C at 2019-2-26 16:31

Hi ,

Yes I have used the AWG before you can see in the picture the model number
and the firmware model number does not match !!Meter Serial No: CN1848008001214

Alan_C · Post time 2019-2-26 16:18:29

How can I fix this Problem Please Help ??

Alan_C · Post time 2019-3-5 06:09:22

Edited by Alan_C at 2019-3-5 06:14

amy replied at 2019-3-1 08:26
Sir, please give me the serial number of your scope, it is on the battery cover.

Hi Amy

here is the Serial No: CN1848008001214

Alan_C · Post time 2019-3-28 02:40:13

Edited by Alan_C at 2019-3-28 05:27

why is that a 30-year-old fluke multimeter is 5x faster than this hantek on DMM mode reading Resistance is very slow & IT TAKES FOREVER TO READ A CAPACITOR VALUE !!!

Can this be fixed with a firmware update ???

Please work on the DMM it is very slow !!

Alan_C · Post time 2019-3-28 05:32:51

amy replied at 2019-3-6 15:08
Sir, I think your oscilloscope doesn't have a signal source.
It was our fault. Label model and in ...

Hi the seller on Aliexpress won't replace it because
the protection time has expired.

is it possible that you replace it for me ??

Update the firmware of Hantek2D72/2D42/2C72/2C42

This post contains more resources