Hello. Thank you very much that in the new firmware for February they implemented the function of at least m maximum. The device works better with this firmware.
I have on model 2D42 all works. To see the oscilloscope signal from the generator, you need to run it by pressing the button it will change from red to green, then if you close the probes and select the Scope function, you can see the signal. The mass during the test can not be connected
Try to connect the cable to the correct USB port on the charged batteries and the device off and press F1 without releasing the power button. If it does not work-try to turn the type-C and connect to another computer socket, may not have enough power due to poor contact in the socket
[Copy link]
Post time 2019-2-23 23:21:04