Hi. My 2D72 is dead, no powering on and not charging (all led is always off). I bought it from Hantek online store about two yers ago.
Battery ok, about 4 volt.
Probably usual known problem, but page with files and explanation is expired.
What should I do?
Hi, I experienced the same initial issue as levj, however I measure 0V at all points when using the screws as ground. My board differs slightly from the posted image - I have attached an image. I disconnected the top board and used a USBC power supply while testing the points. Please let me know if there is anywhere else I should check!
Thanks,
Ryan
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
ok, I try to short pin 6 and 7 of u6 and it go with battery.
I not shure it's a good things, but now I know that my 2d72 work and problem is U6.
I wait for it.
We initially suspect that the U6 is faulty. If you can find this chip, please replace it to try.
The model of U6 is HM4052. If you can't find HM4052, you can try it with another chip (ETA6002). They should have the same function.
If you are unable to complete these, please contact your seller for renovation.
Hi amy, thx for answering.
5v on fuse and on capacitor, but no 4.5v on C19 and no 3.1v on L5.
U6 becomes hot (id marker is not visible on IC, so I not see his datasheet).
C19, C15 and C21 is as shorted (not have schematic, so I do not know if connected to U6).