I bought this Hantek 6022BE, but the driver fails.
I have the following situation :
- Hantek connected to Laptop via USB cables
- Radio VHF 5 watts transmission
- Oscilloscope Probe is not connected to target Radio yet.
The problem :
- On the Radio just click on Transmission button PTT for a second.
Consequences :
- The oscilloscope freezes
- The windows hantek driver fails with a message
" driver is down"
I just bought this oscilloscope to measure some signals on that Radio.
But the oscilloscope fails and freezes everytime the Radio makes a
quick transmission.
So the oscilloscope doesn't work at all when transmission is started.
Then I can not measure anything.
Please help,
Thanks.
Author: Newbee Time: 2018-7-13 08:13
Sir, please send a message to me caiyijun@hantek.com
Please give me your computer system nformation, take a photo.
Author: amy Time: 2018-7-19 09:50
Sir, when not input the signal on that Radio, did the scope work normally? Author: Evandro Time: 2018-7-24 03:34
Answer to your question : The scope is not connected to Radio.
The probe is just like around on the table. Or nearby.
PC is showing normal.
Then I just click once in Radio Transmitter.
And that is it. I get a message on PC, Driver failed. Scope freezes on that moment.
I can not measure anything.
Thanks,
Evandro
Author: Evandro Time: 2019-6-26 07:20
Hi
Is there any new reply on that post.
I am still facing issue with Scope.
And so far not possible to use it.
Thanks. Author: amy Time: 2019-6-26 09:16
Sorry, I missed your question.
Please upload a picture of your connection method when you measure your signal.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)