Electronic Engineer Discuss

Title: Tekway DST 1102B - Self Calibration stops at step 26 [Print this page]

Author: timbocgn Time: 2018-1-28 06:44
Title: Tekway DST 1102B - Self Calibration stops at step 26
Dear Sirs,

I just started a self calibration on my DST 1102B. This stops at step 26 - the device freezes, nothing happens. I waited for roughly 15 min - no effect. I had to switch off the device. I repeated it twice - same behaviour.

SW Version is 2.06.3 (120507.0), HW version is 10070x555583e9.

Any ideas?

Best regards,

Tim Hagemann.

Author: timbocgn Time: 2018-1-28 22:10
Did just another test - waited 2h to warm up, then tried self calibration - same behaviour.

But it is step 23 and not 26 as I stated in the original post...

Author: amy Time: 2018-1-29 10:10

timbocgn replied at 2018-1-28 22:10
Did just another test - waited 2h to warm up, then tried self calibration - same behaviour.

But it ...

Sir, please send a message to our email support@hantek.com

Author: timbocgn Time: 2018-1-29 17:46
Hi Amy,

thanks for your reply - just wrote my story to the support mailbox!

Cheers,

Tim.

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)