Electronic Engineer Discuss

Title: Hantek DSO5102B. Need firmware [Print this page]

Author: giniyazovrr Time: 2017-5-18 17:21
Title: Hantek DSO5102B. Need firmware
Edited by giniyazovrr at 2017-5-18 19:36

Hello.
DSO5102B
sw version: 2.06.3 (140211.0)
hw version: 10070x555583ed

Need firmware, which allows you to display a table with the results of measurements.

Author: amy Time: 2017-5-19 08:44
Edited by amy at 2017-5-19 08:46

Please send a message to my email caiyijun@hantek.com to get the firmware.

Author: jasom Time: 2022-1-27 07:08
Hello, can You provide that firmware for me too?

sw: 2.06.3(130329.0)
hw: 10070x555583ed
sn: T 1G/012 009669

Thank You very much

Author: amy Time: 2022-1-27 11:43
Edited by amy at 2022-1-27 11:46

jasom replied at 2022-1-27 07:08
Hello, can You provide that firmware for me too?

sw: 2.06.3(130329.0)

Does the oscilloscope work normally?
It should be noted that because the product is very old, updating firmware may cause the oscilloscope to fail to start. If this happens, we have no way to fix it, so I do not recommend you to update the firmware.
If the oscilloscope has affected your use, you can update it to try.
[attach]4845[/attach]
Attention, if the firmware version number earlier than 2013, such as 120505.0 or 120825.0, DO NOT update with this firmware.

Author: jasom Time: 2022-1-28 02:02
Scope is working but I just want table with measurements like in some similar scopes.

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)