Title: DSO5102P flies firmware [Print this page] Author: fobos Time: 2017-3-28 19:15 Title: DSO5102P flies firmware Good day! I DSO5102P firmware from 20160919, during the measurement korretno stops responding to button presses. Some buttons will not react to pressing, the pressing part is not fit for purpose. tried to update the firmware. USB-Flash detected, but due to the fact that some buttons aren't responding to update the firmware you can't. After several on / off power press the button to upgrade the firmware and recovers, but after a few measurements the problem recurs.
Please help what can I do in this situation? Thank you!
Author: fobos Time: 2017-3-28 23:07
can send the dump of the FLASH for DSO5102P? fobos_st@mail.ru
PS. Sorry for my bad English. Author: amy Time: 2017-3-29 10:23
Sir, please give us a video to study. Author: fobos Time: 2017-3-29 12:25
you can even show a log of the boot, removed from the UART Author: fobos Time: 2017-3-29 12:41 https://cloud.mail.ru/public/FrFy/yUmZmT5Tp Author: fobos Time: 2017-3-30 04:42
video https://cloud.mail.ru/public/LnXW/C89F9p9K8 Author: amy Time: 2017-3-30 09:34
Please refer to the video to operate. And press F2 to recover the system.
[attach]1449[/attach]
If the problem exists, please let me know. Author: fobos Time: 2017-3-30 15:09
The problem remained. Video after recovery at F2. https://cloud.mail.ru/public/9mph/HAepQzvjL Author: fobos Time: 2017-4-1 17:09
Hello, tell me, can you help me in my problem? SN T1G/136012546.. unable to connect to the oscilloscope via the UART, a JTAG programmer to upload the firmware to the flash ( if it is possible to provide a dump)...willing to consider any solution. Author: amy Time: 2017-4-10 15:44 Edited by amy at 2017-4-10 15:45
Please send a message to my mail, caiyijun@hantek.com.
The link can't be opened.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)