Title: DSO1200 dead after firmware upgrade [Print this page] Author: bucks Time: 2016-9-27 20:55 Title: DSO1200 dead after firmware upgrade Hantek DSO1200 dead after firmware upgrade.
1) Updating the firmware to 1.29 from a USB drive.
2) Firmware was broken by 70%, but the device continues to operate.
3) Turn off the device in a standard way (the button on the front panel).
4) After switching on ran ROLLBACK scale (firmware rollback).
5) The device after rollback went to reboot and shut down completely.
6) Now when press the on button produces beep and turns off after 5 seconds
(Display is dark all the time)
Need flash memory dump.
Sorry for my English. Russia here.
Author: amy Time: 2016-9-28 13:07
Sir, please send a email to support@hantek.com to get more support. Author: bucks Time: 2016-9-29 22:21
Dear amy. I write mail but silence. Author: amy Time: 2016-10-9 09:18
Sir, sorry to reply you so late. We have contact you via E-mail. Please check. Author: bucks Time: 2017-1-14 02:57
Thank you! Now my oscilloscope working!
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)