Title: TO1154D [Print this page] Author: e_admin678 Time: 2023-1-30 10:35 Title: TO1154D Customer consultation
Hola saludos desde Venezuela.
Tengo un hantek modelo TO1154D
Y necesito aprender a actualizar el software y el firware.
Una pregunta: tengo que conectar el TO1154D a una computadora con el cable usb-c ?
Author: e_admin678 Time: 2023-1-30 10:36
Upgrade
The firmware can be upgraded using USB storage devices. The whole process takes
about two minutes.
Perform the following steps to upgrade the firmware:
1. Insert the USB storage device with only an upgrade package into the USB HOST
interface on the side panel of the oscilloscope.
2. Click [Setting] in the main interface to enter the setting interface.
3. Click Upgrade on the Setting interface and click the upgrade tab in the middle of the
screen to upgrade the firmware.
4. After the upgrade, the oscilloscope will restart and the firmware version will be
updated. The self-calibration should be performed after upgrade.
After the upgrade is successful, the saved files and pictures will be cleared.
Note: The USB storage device can contain only the upgrade file, and the name of
the upgrade file cannot be modified randomly as shown in the following figure.
Otherwise, the machine cannot be upgraded normally.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)