Electronic Engineer Discuss

Title: TO01254D [Print this page]

Author: Joevy Time: 2022-11-28 15:20
Title: TO01254D
TO01254D I can't connect machine with pc, how do i edit the arbitrary waveform. also any time machine is switch on i have to calibrate it before i can get accurate readings. Hantek should do something because this is a new product it doesn't have to start with problems. Can not even register my tool because the name is not added to the options available.

Author: Jing Time: 2022-11-29 16:50

Dear Sir，
When the machine is connected to the computer, can the device manager of the computer correctly identify the machine? What is the name of the machine? May I ask whether you have downloaded IO? Is it carried out according to the instructions?

Author: Joevy Time: 2022-12-4 10:31

Jing replied at 2022-11-29 16:50
Dear Sir，
When the machine is connected to the computer, can the device manager of the computer ...

No please the computer can not identify my machine

Author: Joevy Time: 2022-12-9 10:40
I was doing voltage testing with the oscilloscope and i connect the probe to the signal generator instead of CH1, now the machine can be turn on alright but it cannot do any measurements both the oscilloscope and multimeter and of course the signal generator stop working. i know this is my fault not HANTEK. So please can you advise me how to repair it? because this tool is very useful to me.

Author: Jing Time: 2022-12-12 11:01

Joevy replied at 2022-12-4 10:31
No please the computer can not identify my machine

Dear Sir，
Please provide the related video of your connected machine, so that we can better reference the problem.

Author: Jing Time: 2022-12-12 13:31

Joevy replied at 2022-12-9 10:40
I was doing voltage testing with the oscilloscope and i connect the probe to the signal generator in ...

Dear Sir，
To repair the problem of signal source, the chip shown in the following figure needs to be replaced. The model is LMH6702MAPB.

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)