Title: DSO 5102P no synchronization when measured sinus from 10 MW to 130 MW (RMS) [Print this page] Author: Ben_Gunn Time: 2022-10-21 03:08 Title: DSO 5102P no synchronization when measured sinus from 10 MW to 130 MW (RMS) Edited by Ben_Gunn at 2022-10-22 00:33
Hello everybody!
When measuring a low voltage signal (rms), the waveform has artifacts! Artifacts occur with an input sinusoidal signal from 10 mV to 100 mV (rms) at a frequency from 10 Hz to 20 kHz on both channels.
https://disk.yandex.ru/d/TrP0R_QCHE9eFw?spm=a2g0s.imconversation.0.0.6b113e5fjQ7gHI
https://disk.yandex.ru/i/pP6UxPadSdhtNA?spm=a2g0s.imconversation.0.0.6b113e5fjQ7gHI https://disk.yandex.ru/i/vF5vcQPlkIVUqA
What can be done?
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)