Title: DSO2D15: no trace + no reaction to buttons after swithing to 8Mpt buffer [Print this page] Author: Sserlet Time: 2022-1-3 18:44 Title: DSO2D15: no trace + no reaction to buttons after swithing to 8Mpt buffer Hello,
I recently bought a Hantek DSO2D15. I switched the buffer size from the default 4kpt to 8Mpt, and since then I have no trace on my DO (I do see the labels), and it does not react anymore to any button or knob.
I did several times a power off and power on again, but with no effect: the screen comes up with all the labels, but there is no trace, and it does not react at all to pushing buttons or turning knobs.
Is there a way to restore it to default setup? Needless to say that the button "default setup" does not work, so I would need another way.
Author: Sserlet Time: 2022-1-4 14:44
I have sent you an E-mail. Thank you for your help. Author: Vagrex Time: 2022-1-25 07:42
Hello.
I have exactly the same problem. When i switched to 8Mpt it stucked and i can't do anything.
Is there any solution?
model: DSO2C15 Author: Vagrex Time: 2022-1-28 18:28
I was be able to unstuck it by doing update. For some reason utility button worked. But now there is a problem about which there is another thread, the Issue with higher memory depth here. The higher memory depth was the reason of stuck problem so i beleave that the two problems are related. Author: wangshuang Time: 2022-2-12 09:55
Vagrex replied at 2022-1-25 07:42
Hello.
I have exactly the same problem. When i switched to 8Mpt it stucked and i can't do anything.
...