Title: Error 0x20003 on self calibration dso5102P [Print this page] Author: xray52 Time: 2021-12-19 23:45 Title: Error 0x20003 on self calibration dso5102P Hello!the trigger does not work on the DSO5102P. I do the following: I connect the probe to the oscilloscope generator and press the AUTOSET button — the relay clicks inside the device a few times but the picture does not stabilize on the screen.
During the self-calibration (Self Self-Calibration), an error 0x20003 appears.
I am a good technician: is it possible to solve the problem by myself? Below data of my DSO5102P
With Best Regards
Andrea Ciacci[attach]4724[/attach]
Author: Jing Time: 2021-12-21 15:46
May I ask whether the machine should be warmed up for at least 30 minutes in advance during calibration, and there should be no input signal during calibration, and do not connect any wires to the machine. Please calibrate again to see if it is normal. If the problem still exists, please take a video of your problem and send it to support@hantek.com. Author: xray52 Time: 2021-12-21 21:38
Thanks for the reply. I have complied with the rules you indicated, but the problem persists. I'll do as you said. Thanks again Author: wangshuang Time: 2021-12-24 13:56
Please input a signal and see whether a signal at Tp403.