Title: 2D42: the scope TRIG again after STOP [Print this page] Author: Carlitos61 Time: 2021-8-22 23:39 Title: 2D42: the scope TRIG again after STOP When I set the scope in NORMAL trig and I capture a signal, then I press STOP (red button), if a new signal arrives the scope trigs again losting the stopped trace (error).
This behavior is always repeated only one time after the STOP... why?
While in SINGLE mode, after the scope captures a signal it STOP and any other new signal cannot retrigger the scope (right).
Another thing is:
If I set the scope in NORMAL trig and no signal is present, the scope says "WAIT" on the top left corner. Now I decide to press stop (whitout any signal) the scope says "STOP" red.
If a signal arrives the scope captures it even if "stopped".
It seems that the trigger is running always even the capture is stopped!
Why these stranges behaviors?
It is possible a workarround?
Thank you, Carlos.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)