Electronic Engineer Discuss

Title: Hantek 1833C Driver [Print this page]

Author: ying Time: 2021-7-20 09:03
Title: Hantek 1833C Driver
Edited by ying at 2021-7-20 09:21

Customer Consultation

Hello

I recently purchased a Hantek 1833C LCR meter

However the USB interface does not work, although it will show up as Com 3 in normal mode and the STM32 DFU in boot loader mode (see pictures below)

Also the PC program does not find the unit.

The upgrade program can not find the unit either, although it shows up in the hardware manager.

Model is Hantek1833C

Software V is 20190903AM

Hardware V is 0

Please help me to get this to communicate.

[attach]4468[/attach]

[attach]4469[/attach]

[attach]4470[/attach]

Author: ying Time: 2021-7-20 09:32
Reply

Please update the latest firmware for your device. Firmware download: http://www.hantek.com/products/detail/16180

Then try to connect the device with PC again.

Author: poohcat Time: 2021-7-21 00:14
while i appreciate the sentiment, as i said in my post, the USB port doesn't' work so i cant upgrade the firmware...that is the whole point...i want to upgrade the firmware but i cant because the device isn't recognized by the PC as shown in the pictures

Author: ying Time: 2021-7-27 08:13

poohcat replied at 2021-7-21 00:14
while i appreciate the sentiment, as i said in my post, the USB port doesn't' work so i cant upgrade ...

Firstly, please uninstall "STM32 DFU" in manage device. Then remove the USB cable, and connect the USB cable again, then install new device driver for the device.

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)