Electronic Engineer Discuss

Title: Hantek1008C [Print this page]

Author: amy Time: 2021-3-11 11:16
Title: Hantek1008C
Customer Consultation

Hello,

I recently purchased Hantek 1008C to measure 24VDC circuits and at times 230VAC. I have it currently connected to a 24VDC circuit and see the O-Scope tops out at 20VDC.

I thought the probes that came with the O-scope can measure up to 400VDC. Can you please help with this?

Author: amy Time: 2021-3-11 11:18
Reply

Maximum input voltage is input protection voltage.
If you want to measure 230VAC, please set the probe attenuation to ×10.
If you want to test for a higher voltage, it is recommended to use a probe with 100 times attenuation.

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)