Title: DSO2C15 firmware [Print this page] Author: jwpark Time: 2021-2-27 20:50 Title: DSO2C15 firmware Edited by jwpark at 2021-2-27 20:52
I bought the dso2c15 a few days ago When I press the zoom button, the screen freezes.
So after receiving the dso2000 firmware from hantek website this site, and I updated the software to 20210223.00.
Now zooming is fine, but at sampling below 500MSa/s, the trigger only catches half of the screen.
As a result, 1khz is displayed as 2khz. Therefore, it is not possible to measure frequencies below 1MHz.
Frequency and trigger work normally only at 500MSa/s sampling.
So I want to downgrade to the original old version firmware. where can I download it?
Author: jwpark Time: 2021-3-1 12:11 Edited by jwpark at 2021-3-1 16:34
Author: jwpark Time: 2021-3-3 22:08
Everything seemed to be fine, but all of a sudden the front usb was not recognized.
I thought it was a hardware defect, so I asked hantek service for help,
and when I got a repair program from the person in charge and ran it,
everything was back to normal.
After that, I updated to the latest firmware and now everything works fine.
Thanks to hantek service representative. Author: Pireus Time: 2021-3-4 02:55
And what kind of program is this? You can post it. There were also problems with the flash drive, I had to select from several. Author: jwpark Time: 2021-3-4 19:24
See the "Reply #22" post in the second article site link above. It is described in detail. I also referred to that article.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)