Electronic Engineer Discuss
Title: Update Firmware by software for Hantek2000 Handheld Oscilloscope [Print this page]
Author: amy Time: 2020-12-18 14:08
Title: Update Firmware by software for Hantek2000 Handheld Oscilloscope
Edited by amy at 2020-12-18 14:18
1. Download the software in this link and install:
2. Open the scope and connect it to your computer, run the software, click "Help->Checkupdate" to open the update interface.
[attach]4056[/attach]
3. Click “Start” to start update. update as prompted.
[attach]4057[/attach]
4. The content indicated in the figure below is not displayed completely, please refer to this, "Turn off the oscilloscope, press F1 and hold, then press the power button until the RUN/STOP light flashes red and green, release all the buttons, and the device will start to upgrade."
[attach]4058[/attach]
After update, the scope will start automatically.
Author: QMESAR Time: 2020-12-18 17:54
Edited by QMESAR at 2020-12-18 18:39
Hi Amy
This update just broke my 3 day old scope ,
I followed your instructions
(1) the button flashed once green red I released it the software did something and then afterwards I have only run stop button constantly ON RED se below
How Can I recover the instrument
Author: QMESAR Time: 2020-12-18 19:23
Hi Amy ,
I recovered it by downloading the dfu file and then upgraded
Author: 李继春 Time: 2020-12-19 09:34
艾米汉泰2000当中的2D72最新固件是多少版本呀?
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/) |
Powered by Discuz! X3.2 |