Electronic Engineer Discuss

Title: SCPI Command to Start/Stop Single Trigger for DSO4004 oscilloscope [Print this page]

Author: ercolino Time: 2020-10-23 22:04
Title: SCPI Command to Start/Stop Single Trigger for DSO4004 oscilloscope
Is there a SCPI command to toggle Run / Stop mode or to produce a single trigger on a DSO4254C (DSO4004 series) oscilloscope?
I have tried "TRIGger:FORCe", "TRIGger:MODE", "*TRG", "TRIGger:STATus". None has worked.

I am controlling the osciloscope from Matlab and most of the documented commands work as expected.

Thanks in advance

Author: ying Time: 2020-10-29 16:40

Please download SCPI document from the website: http://www.hantek.com/products/detail/12167

Author: ercolino Time: 2020-10-30 01:48

ying replied at 2020-10-29 16:40
Please download SCPI document from the website: http://www.hantek.com/products/detail/12167

Thanks

I have already downloaded the document. I couldn't find any command that seems to perform the start/stop/single trigger function.

I have also tried (as mentioned above) the commands that can possibly perform this function without success.

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)