Title: 1008C incorrect amplitude [Print this page] Author: OASJ2YSeeEhBQo1 Time: 2020-8-28 14:05 Title: 1008C incorrect amplitude Hi,
I'm with a 1008C oscilloscope with the following problem:
The device is showing an incorrect value for the amplitude of a signal, for example, the 2Vpp test signal shows only about 400mV. The shape of the signal looks ok, just the amplitude is wrong. It is not a problem with the compensation output, it's working fine. I tested all inputs with other signals and the problem was the same. The software settings are correct too.
[attach]3805[/attach] [attach]3806[/attach]
I know it's hard to guess without more details but, do you have any idea of what can cause this kind of problem? Is there any procedure that I can do to test it further?
Does all channels have this problem or only channel 1? If only channel 1, something should be burned out. Author: OASJ2YSeeEhBQo1 Time: 2020-8-29 23:45
All channels have the same problem. Author: wangshuang Time: 2020-9-1 10:26
Hantek provides free maintenance services, and users only need to bear the round-trip freight. If you are willing to return it to the factory for repair, please provide the purchase channel and product serial number to my email address, and sales will contact you. My address is wangshuang@hantek.com Author: OASJ2YSeeEhBQo1 Time: 2020-9-1 13:33
I have already sent an email to Amy before post here in the forum but I got no reply. I will send you a message.
Thx.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)