Electronic Engineer Discuss

Title: DSO4254C信號源功能不支持? [Print this page]

Author: Jameswade Time: 2020-6-10 10:05
Title: DSO4254C信號源功能不支持?
Edited by Jameswade at 2020-6-10 10:35

DSO4254C信號源(Wave Gan)功能不支持?
firmware：dso4kb_20200529.upk
按下Wave Gan按鈕，如下圖顯示：

Author: Jameswade Time: 2020-6-12 08:59
No one to help? I have written to the service mailbox, but there is no response.

Author: wangshuang Time: 2020-6-12 09:39
在这之前升级过其他固件吗？固件版本号是什么？机器后面的序列号是什么？

Author: Jameswade Time: 2020-6-12 15:19
Edited by Jameswade at 2020-6-12 15:21

wangshuang replied at 2020-6-12 09:39
在这之前升级过其他固件吗？固件版本号是什么？机器后面的序列号是什么？
...

升级其他固件如下(共7個)：
机器后面的序列号(已經比對過是相同)：

Author: Jameswade Time: 2020-6-16 14:39
I can't see the sincerity of the R & D team to solve the problem.

Not even a reply.

Author: wangshuang Time: 2020-6-18 13:30

Jameswade replied at 2020-6-16 14:39
I can't see the sincerity of the R & D team to solve the problem.

Not even a reply.

Please use the firmware update in the link (only for this oscilloscope.)
https://fil.email/1j3vHHx8

Author: Jameswade Time: 2020-6-18 17:42

wangshuang replied at 2020-6-18 13:30
Please use the firmware update in the link (only for this oscilloscope.)
https://fil.email/1j3vHHx ...

After updating the firmware you provided.
My DSO4254C The waveform generator is working normally.
Thank you very much.

Author: Alexey76 Time: 2020-9-17 18:10
A similar problem after updating the DSO4254C software, the generator stopped working. Where to get the previous firmware to restore the oscilloscope to work

Author: ying Time: 2020-9-25 16:25

Alexey76 replied at 2020-9-17 18:10
A similar problem after updating the DSO4254C software, the generator stopped working. Where to get ...

Please press "Utility->System Information" button and send us a screenshot to study.

Email: support@hantek.com

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)