Title: 1008C All input channels show max 1V [Print this page] Author: QMESAR Time: 2020-4-16 19:48 Title: 1008C All input channels show max 1V Edited by QMESAR at 2020-4-16 19:49
Hi Team
I am so sad I love my 1008C scope ,Yesterday I worked with it in an area where there were a lot of ESD running even my PC stopped (freezed some times)
the result of this is my scope is now broken all the channels can only show max 1V mexample I apply 5V DC to channel 1 with probe set at x1 I see only 1 V
if I connect the probe to the calibration points which should be 2Vp-p I get a 500mV p-p signal
Can you tell me if it is possible to repair the scope ? Can I test some componets to track the broken commponent
I appreciate any help
Regards
Author: amy Time: 2020-4-17 10:50
It's not easy to judge the specific problem.
Please contact your seller to return factor for repair. Author: QMESAR Time: 2020-4-17 12:56
Hi.
To return it for repair will cost the same a new one,
I just ordered a new one thanks
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)