Electronic Engineer Discuss
Title: DSO1202B shutting down [Print this page]
Author: ying Time: 2020-4-16 14:34
Title: DSO1202B shutting down
Customer consultation
A few years back i bought a Hantek Oscilloscope DSO1202B. Today i noticed that the device is permanently shutting down. If the device is turned on, it takes about 3 minutes till the Display is dimmed. After 1 minute the device shuts itself completely off. I can’t turn it back on. I Need to disconnect the battery an plug it back in. After that the device works fine till it shut down again.
I dont think that the battery is faulty because if i run the oscilloscope without the battery and only with the power Adapter - the Problem is the same.
I just installed the newest Firmware but it doesnt help.
I hope you can help me somehow.
I am Looking Forward to hear from you!
Author: ying Time: 2020-4-16 14:37
Reply
Please press "Utility" button to check Shutdown setting.
Author: ying Time: 2020-4-16 14:39
If you can not sove the issue, please set the backlight.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/) |
Powered by Discuz! X3.2 |