Title: Hantek6254BD - after restart all chn max negative [Print this page] Author: ChristianB Time: 2020-4-8 18:05 Title: Hantek6254BD - after restart all chn max negative Hello,
I just go a new Hantek6254BD and tested it. First it looked everything works like expected but after a restart of the PC all channels are stuck to max nagetive value. Changing the range has no effect and calibration runs forever. Only changing the coupling to GND brings a channel to zero but chaning it back to DC or AC will result again in max negative amplitude. If I change the visual offset of a channel the line stays within the visible are and after a few seconds jump back to max negative value. Attached you will find some picture of this.
I tried autoset and factory settings and even connected the device to another PC as well but the results stay the same. Is the device broken or is that a firmware issue? Software is from http://www.hantek.com/en/productdetail_10164.html .
Author: ChristianB Time: 2020-4-8 18:27
nvm after leaving the device depowered for some minute everything went back to normal. Author: wangshuang Time: 2020-4-14 16:32
Please record this issue with a video so that I can understand it more clearly and feedback its solution.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)