Title: Hantek DSO5102P saves CSV to USB flash drive but no files are shown on PC [Print this page] Author: SlimEddie Time: 2020-1-27 07:30 Title: Hantek DSO5102P saves CSV to USB flash drive but no files are shown on PC I have recently purchased DSO5102P and tried saving captured waveforms in CSV format to USB flash drive. Osciloscope says that CSV file was saved and shows them on osciloscope but when I connect the flashdrive to PC I don't see any files at all.
Is this a known issue and is there a fix for it?
Flashdrive is 8GB (FAT32).
Osciloscope: DSO5102P
SW version is 3.40.0 (180120.0)
HW version is 1010xffff8108
Author: Ily Time: 2020-1-27 14:04
Yes, this is not news. Try a different flash drive or format it with a different program. Author: amy Time: 2020-2-14 09:40
Please refer to this post to do USB disk partition to try.
I know this answer is a bit outdated, but I bought a DSO5202P digital oscilloscope just a few days ago and I had the same problem. I only comment to catch any other users looking for a solution.
So in my case the process was to format my usb stick with another program.
I used Rufus3.13 software, with settings as shown in the image below.
Note that there may be a limit to the size of the partition that the oscilloscope can use.
In this case, we do not need to buy a new stick, we just destroy the old partition, and create a new one, using only part of the available capacity. (in my case 16GB)
Just search for the procedure, its an easy task that can be done from windows.
Hope I helped,
Hermes Daviskas
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)