Title: Hantek1833C Help [Print this page] Author: sergei21 Time: 2019-12-22 21:12 Title: Hantek1833C Help bought a part and he is very mistaken after calibration.
numbers can change randomly.
watch the video
Author: sergei21 Time: 2019-12-24 17:13 https://yadi.sk/i/zn3E1IlLEg1crQ Author: sergei21 Time: 2019-12-24 17:14 https://yadi.sk/i/h5HFAmCq4tT6xw Author: sergei21 Time: 2019-12-24 17:16
firmware update? give me please Author: wangshuang Time: 2019-12-27 11:44
Sorry for not being able to reply to the post in time, the problem has been feedback to the engineer, I will reply to you as soon as the result is available. Author: sergei21 Time: 2019-12-28 14:54
waiting for an answer Author: wangshuang Time: 2020-1-6 11:58
Calibration should be performed in both short circuit and open circuit. did you do this? Author: sergei21 Time: 2020-1-7 00:24
I did open and closed calibration
The device is operating chaotically.
and it’s not convenient that after turning off the calibration needs to be done again
I will make a video and post it.
jumps 0.00 ** it turns out the device is 0.00 and not how I wanted 0.0000 Author: sergei21 Time: 2020-1-7 00:26
Why is the device inside without shielding? with such accuracy it is necessary Author: wangshuang Time: 2020-1-7 11:25
users need to calibration in both short circuit and open circuit. from the video, i see it's correct in short circuit. But what is your meaning? numbers can change randomly occurred after open circuit calibration? Author: 3apw Time: 2020-6-27 15:36
Hello,
This week I purchased your LCR meter Hantek 1833C and happy with the measurement result.
Unfortunately I cannot find in the Hantek 1833C manual how to make the correct calibration.