Electronic Engineer Discuss

Title: 24LC64 DSO6xx4 V1.06 Firmware [Print this page]

Author: cure4you Time: 2019-12-13 05:58
Title: 24LC64 DSO6xx4 V1.06 Firmware
Dear Team,

I have a problem with my (hopefully you'll help me it is a Voltcraft) DSO-3204-USB.
It should be a DSO6xx4 from Hantek.
The U807 burned some how and I plan to replace the IC by the 24LC64 chip.
When I replaced the chip, can I get the Firmware from somewhere and how can I write the firmware in to the device then ?

Board notes:
DSO6XX4 V1.06 / 20160416, siver Label sticker : 64C01480.

Whats going on: The Device is recognized by the Device Manager of Win10, but the DSO Software never connect to it. It says always "Searching" but will never find.
The red LED is always blinking. The yellow LED on the board will turn on only around 2 seconds after plug in the USB cable.
What I checked:
U19 and U907: both ok, output V 1,2 and 1,8V.
U807 Vss: 3,2V but the top of the IC is damaged by over heating, the label is unrecognizable.

I could not upload a picture. The Upload says always Server iO error.

Thank you very much .
Robby

Author: OASJ2YSeeEhBQo1 Time: 2019-12-13 07:36
These threads may help you:

https://www.eediscuss.com/forum. ... page%3D1&page=1

https://www.eediscuss.com/forum. ... 5&fromuid=26055

Author: cure4you Time: 2019-12-14 22:53
Hello,

thanks & sorry but this does not help as far as I need.
First Thread is about which chip is U807, but this I already knew.
Second Thread is about to use CyConsole. I extracted Hantek6000 program.zip, but I can't read the document operate.doc because it is only language chinese. Is it available in english?
And is this Thread https://www.eediscuss.com/forum. ... 5&fromuid=26055 really the right one to write the correct Firmware to a DSO6xx4 device where the U807 chip was replaced by a new empty one?
I can't read the document operate.doc because it is only language chinese. Is it vailable in english?
Inside the zip file is a file "DSO6106BD20160601.iic". Is this the Firmware for a DSO6xx4 Oszi?
Thank you in advance,
Rob

Author: cure4you Time: 2019-12-18 05:31
Hello,

I want to install firmware on the replaced U807 chip...
I extracted Hantek6000 program.zip, but I can't read the document operate.doc because it is only language chinese. Is it available in english?
Is there an other how to regarding installing the firmware on that chip?

Thanks Rob

Author: amy Time: 2019-12-18 16:42
[attach]3325[/attach]

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)