Title: Save settings on hantek2008 [Print this page] Author: mecanicus Time: 2019-10-15 17:51 Title: Save settings on hantek2008 Hello, i am new to hantek forum and have a question about storing the settings.
I set the toolbar then i go to files-> save setting and close the program. When I open the program again there is no toolbar. What am I doing wrong? I did that in admin mode as well, no progress! System is newest WIN10.
mecanicus
Author: wangshuang Time: 2019-10-16 13:33
System settings are default,the "setup" in 1008C is for waveform setting. Author: mecanicus Time: 2019-10-16 23:44
So can I change default setting that way that it opens always with Toolbar on? Author: wangshuang Time: 2019-10-17 13:42
Sorry,you can't.This is default.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)