Title: Hantek 2D82Auto Firmware [Print this page] Author: Sniperfi Time: 2019-9-14 11:45 Title: Hantek 2D82Auto Firmware I recently purchased a new 2D82Auto and need to know if I need to update the firmware? There is a firmware file on the web site but no information on what version. My 2d82Auto lists under system a v04 Author: testequipment12 Time: 2019-9-19 08:34
that is the new one Author: Sniperfi Time: 2019-9-20 10:57
Yes it's the new 2d82Auto. Author: uncle_sem Time: 2019-11-8 19:11
which is the last version of the firmware with settings save enabled? Author: amy Time: 2019-11-13 10:10
Please use the software to update.
[attach]3246[/attach]
Author: crystache Time: 2019-11-17 00:41 Please, a little help. I try to upgrade hantek 2d82 but I don't know why it lasts so long. the story is longer because I received the defective device from banggood. I contacted them but they did not respond. did not start. I managed to start it but the menu was a combination of English with Chinese and letters missing.
Author: amy Time: 2019-11-18 16:16
Please confirm the .dfu file is not corrupted.
And upload some pictures of current status to study. Author: rannokas79 Time: 2019-11-21 17:34
I have same problem.
device not working after trying to update.
program verified that firmware file not corrupted Author: Pav Time: 2019-12-23 05:11 Edited by Pav at 2019-12-23 08:41
I got this Oscilloscope from Bangood with same buggy firmware ,that didn't display English. It was looking like just random pixels, instead of alpha/numerical characters.
Newer firmware fixed it.
I'll keep it short , and simple. Here's is how I got it fixed in first try.
At first ,it wasn't clear to me how to enter DFU mode so:
1 Remove the battery back cover and remove 2 batteries
2 Unplug the USB cable
3 Press and hold F1, plug in the USB cable and connect to the computer.
4 Release F1 immediately after the lower right corner (RUN/Stop) light flashes <--I released the F1 button just after when I saw the green light on ,|> (the play/pause button on the unit).
5 Click the program "Start" button
**Note, please make sure the computer has successfully installed the DFU driver!
This was done with windows 7 64-bit.
The rest info is in the pictures. Please read, before do.
Hope it helps.
Ps: I notest the pictures doesnt show up on some devices. Please let me know if you can't see them below.
Also You have to create an account on this website, and to be loggen in, to see them.
Author: damion Time: 2020-2-21 03:12
I have Hantek 2D82auto and can not power on, the battery is fully charge. Any ideas ??? Author: amy Time: 2020-3-13 17:01
Please remove the batteries.
Press F1 button and connect the scope to your computer via USB cable, and wait for 2s, will the indicator (Run/Stop button) in the lower right corner flash red and green?
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)
