Title: After firmware upgrade the STOP/RUN button does not work correctly at DSO5202P [Print this page] Author: mgrecki Time: 2019-6-26 05:49 Title: After firmware upgrade the STOP/RUN button does not work correctly at DSO5202P Hi,
as in title - I made the upgrade to last available firmware version and just after that the STOP/RUN button stopped to work correctly. When in the normal run (auto/normal) pressing this button does not stop the data acquisition (the button light is always green). If one press "single seq" then this button (after trigger) gets red and pressing it gives no effect... There is a beep sound so it is not the hardware problem (anyway, before the firmware upgrade this button had worked correctly). In order to restore some reasonable operation of the scope I have to restart it or at least press "auto set". This is extremely inconvenient...
Can you provide a corrected firmware or describe the way how to downgrade the scope firmware? The older firmware did not have this problem...
Thanks in advance.
Mariusz
Author: amy Time: 2019-6-26 09:12
Please give me the firmware version you used. Author: mgrecki Time: 2019-6-27 06:33
Author: mgrecki Time: 2019-6-27 06:36
And this the link to the movie showing the problem: http://mghsh.ddns.net/tmp/20190627_001107.mp4 Author: mgrecki Time: 2019-6-29 19:12
Any conclusion? Author: amy Time: 2019-7-1 16:54
Sorry, I tried for several days, but I couldn't connect to the outer net. I couldn't open your connection.
If the file is not large, please email me. caiyijun@hantek.com Author: mgrecki Time: 2019-7-1 22:57
OK, I will copy here the information from "System information window":
model DSO5202P
sw version: 3.40.0 (180120.0)
hw version: 1010xffff8108
serial no.: T1G/138013871
boot count: 18
upgrade count: 0
lcd.front.ts: 3.3.0
Author: mgrecki Time: 2019-7-6 19:16
the problem seems to be solved. I did a system recovery to factory defaults and repeated the firmware upgrade. Now it seems OK...
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)