Title: Hantec 2D42 AWG Signal Generator - Offset does not work ? [Print this page] Author: ivesh Time: 2019-6-22 23:07 Title: Hantec 2D42 AWG Signal Generator - Offset does not work ? Edited by ivesh at 2019-6-22 23:10
Hi,
I canot set the signal generator offset. Has anybody the same issue or am I doing something wrong ?
It does not work on the device and not on on the PC software. I can only set -0.5/+0.5 Volt
ps, I upgraded to the latest firmware today.
All help is appreciated ! Thx
[attach]2970[/attach]
[attach]2967[/attach]
Author: OASJ2YSeeEhBQo1 Time: 2019-6-23 10:23
The maximum output voltage of this AWG is +/-2.5V that is, amplitude+offset voltage must be <=2.5V. You set the amplitude of the waveform for 2V, thus the maximum offset will be 0.5V. Author: ivesh Time: 2019-6-26 19:02
Thank you !
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)