Electronic Engineer Discuss

Title: How to use the counter of HDG6162B? [Print this page]

Author: WisdomAugust Time: 2019-6-20 08:31
Title: How to use the counter of HDG6162B?

The arb./function waveform generator HDG6162B provides a counter which can measure various parameters

(such as frequency, period, duty cycle, positive pulse width and negative pulse width) of external input signal.

[attach]2963[/attach]

Author: WisdomAugust Time: 2019-7-1 08:11
Edited by WisdomAugust at 2019-7-2 08:30

How to Enable the Counter?

Press Counter key at the front panel to enable the counter function.

the backlight of the key turns on and indicator blink.

[attach]2976[/attach]

Input the signal to [Counter In] connector to measure.

[attach]2977[/attach]

Full display counter interface

Author: WisdomAugust Time: 2019-7-2 08:32

Disable the Counter

If the counter is currently turned on and the screen displays the counter interface, pressing Counter

will disable the counter function.

If the counter is currently turned on and the screen displays the counter interface, pressing other

keyboards except Counter will minimize the counter interface.

[attach]2982[/attach]

Mini Display the Counter Interface

If the counter is currently turned on and the screen displays interfaces other than the counter interface,

pressing Counter will switch to the counter interface.

Note: The CH1 sync output will be disabled when the counter is enabled.

Author: WisdomAugust Time: 2019-7-3 08:07

Setup the Counter

Gate time

How to set up the gate time of the measurement system?

Press Gate time softkey, and use the direction keys and knob to modify the current value. The default

value is 1s and the settable range is from 10ms to 16s.

[attach]2984[/attach]

Author: WisdomAugust Time: 2019-7-4 09:36

Sensitivity

How to set up the trigger sensitivity of the counter?

Press Sensitivity softkey. Use the direction keys and knob to modify the current value. The default is

50% and the range available is from 1% to 100%.

[attach]2986[/attach]

Author: WisdomAugust Time: 2019-7-5 08:03

Trig Level

How to set up the trigger level of the counter?

Press TrigLevel softkey. Use the direction keys and knob to modify the current value. The default is 0V

and the range available is from -2.5V to 2.5V.

[attach]2989[/attach]

Note: The system triggers and gets the measurement readings when the input signal reaches the specified trigger level.

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)