How to reproduce the problem:
1. Feed a 10 Mhz / 5.0V sinewave signal to Channel 1
2. Set the timebase to display 2 or 3 periods of that signal
3. Press the "Single Seq" button. This will stop the waveform from updating.
4. Now turn the timbase control counterclockwise several steps to increase the time/div.
After a few steps, the screen will lock, then it goes black, then the unit will reboot into factory defaults with ALL settings gone - even the set color scheme reverts back to the default blue -.
This has to be addressed!
Can other DSO5102P-Users confirm this?
Author: wangshuang Time: 2019-6-11 15:40
Sorry sir,i didnt reproduce the problem,please send us a vidio to study.My email address is wangshuang@hantek.com
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)