Title: Restore Arb wave form 2D42 [Print this page] Author: OASJ2YSeeEhBQo1 Time: 2019-5-22 08:17 Title: Restore Arb wave form 2D42
Is there a way for me to restore the original buit in arbtrary waveforms to my device's memory (I have a Hantek 2D42)? I used the PC software to create some waveforms and test the feature but now I need to restore the original waveforms and I can't see how.
I've already tried to restore the device to factory default but it did not work.
thx
Author: Ben2000 Time: 2019-5-22 17:35
I've lost waveforms too. Moreover, each time when I use PC software to controll AWG, arb waveforms are set to null. I'ts very annoying. Is there any way to save/restore arb waveforms? Author: OASJ2YSeeEhBQo1 Time: 2019-5-22 23:51 Edited by OASJ2YSeeEhBQo1 at 2019-7-2 11:29
Exactly, all my arb waveforms are just a straight line, maybe it was coincidence or not, but I noticed that after I updated my device to the last FW version.
Author: OASJ2YSeeEhBQo1 Time: 2019-6-13 06:18
Well, no answer... so I'll assume that there is no way to restore it.
Can I at least load to the device an arbitrary wave form from a file, for example .CSV using the PC software? Author: amy Time: 2019-6-15 16:47
I've fed back the problem to the engineer. Please wait for some days. Author: OASJ2YSeeEhBQo1 Time: 2019-6-16 00:32
Thank you for the help. I will be waiting for a solution. Author: amy Time: 2019-6-27 11:50 Edited by amy at 2019-6-27 11:53
Please use this test version.The arbitrary waveform of the oscilloscope just shows this function, and has no practical significance, so there is no recovery of these waveforms.
[attach]2973[/attach]
Author: Ben2000 Time: 2019-6-29 02:04
Operation arb waves is much better, now. Thank You! Author: OASJ2YSeeEhBQo1 Time: 2019-7-2 11:36
Thanks Amy, I tested this new version and it solved my problem, now I can upload any arbitrary waveform that I need to my device.
I also notice some other improvements in the software, like now my device's settings are no longer reset to default when connecting to the PC program. Keep the good work it's on the right track. Author: leon Time: 2020-10-29 20:12 Edited by leon at 2020-10-29 20:13
I had the same problem and I wrote new wave forms in csv format.
I only wrote ARB1, ARB2 and ARB3 and did a little guessing but these files are close enough.
Just load these files into the hantek software and your good to go.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)