Electronic Engineer Discuss
Title: How to use the logic analyzer of MSO5202D? [Print this page]
Author: WisdomAugust Time: 2019-5-14 09:06
Title: How to use the logic analyzer of MSO5202D?
There seems no key for logic analyzer on the front panel of MSO5202D.
How to enable the logic analyzer function?
[attach]2854[/attach]
Author: WisdomAugust Time: 2019-5-15 08:55
See the multifunctional key F7 above the VATICAL control?
[attach]2855[/attach]
Press F7 key twice to open the menu and display of logic analyzer.
[attach]2856[/attach]
Logic Analyzer Interface
Author: WisdomAugust Time: 2019-5-16 08:02
Review the logic analyzer menu
[attach]2857[/attach]
Author: WisdomAugust Time: 2019-5-17 08:28
1. Display and Rearrange the Digital Channels
(1) Press F1 (D7-D0) or F2 (D15-D8) softkey to enter the channel group setup menu.
[attach]2867[/attach]
Author: WisdomAugust Time: 2019-5-20 09:18
When Turn On D7-D0
[attach]2875[/attach]
When Turn Off D7-D0
Author: WisdomAugust Time: 2019-5-21 08:09
When Size big, full screen to display 8 channels;
When size normal, full screen to display 16 channels.
[attach]2876[/attach]
Author: WisdomAugust Time: 2019-6-3 08:06
(2) Press F3 (Current) softkey to enable the current channel selection function. Turn the V0 multifunction
knob to select digital channels. And the selected channel display in red.
[attach]2905[/attach]
Author: WisdomAugust Time: 2019-6-4 09:20
2. Setup the Threshold Type of the Digital Channels
(1) Press F4 (Threshold Type) softkey to select the pre-set threshold type or select the user-defined type to set your own threshold level.
Threshold type: TTL CMOS ECL User-defined
Threshold level changes between 2.6V 2.5V -1.3V -8V to +8V.
(2) When select User type threshold, the user sub-menu will appear.
[attach]2906[/attach]
Press F5 to enable the V0 knob to adjust the level value. And press V0 knob to zero the user value.
Author: WisdomAugust Time: 2019-6-5 08:15
Logic Analyzer Flat Input Cable
MSO5102D logic signal input port is shown as follows:
[attach]2907[/attach]
Author: WisdomAugust Time: 2019-6-6 08:15
[attach]2908[/attach]
A Digital Input Terminal
The total of digital signal input terminals is 18, arraged as two rows, GND, D0-D7 and
GND, D8-D15.
B Flat Cable Plug
Plug the flat cable into the logic signal input port in accordance with the sequence of the
input port.
Note: When connect with device, please insert input terminals gently to avoid damaging
cable socket or other components.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/) |
Powered by Discuz! X3.2 |