Electronic Engineer Discuss

Title: DSO1062B Ethernet LAN [Print this page]

Author: ying    Time: 2019-5-6 14:08
Title: DSO1062B Ethernet LAN
Customer Consultaton
I recently acquired a Hantek DSO1062B Handheld Oscilloscope with SW version 2.01.1(170908.0) and HW version 1002.10x55558315. I was trying to use the ethernet jack on the device, but when plugged in to a network cable, the lights do not light up. In addition, under the System Features panel, it shows Net Card "Unsupported". I was wondering if there is a possible firmware update to fix this. Thank you.




Author: ying    Time: 2019-5-6 14:10
Reply
Please refer to "6.13 Example 13: Setting Net IP" chapter in manual to set net IP.
Manual download link: http://www.hantek.com/en/ProductDetail_1_13.html

Author: timothyle97    Time: 2019-5-6 15:06



I tried using the instructions in the manual, but I am unable to find "Pc set" under Utility->System. Screenshots are attached

Author: ying    Time: 2019-5-7 08:19
timothyle97 replied at 2019-5-6 15:06
I tried using the instructions in the manual, but I am unable to find "Pc set" under Utility->Sys ...

The LAN module is optional not standard. If you don't purchase together with the scope, there will be not this function.

Author: timothyle97    Time: 2019-5-7 10:52
Edited by timothyle97 at 2019-5-7 10:54
ying replied at 2019-5-7 08:19
The LAN module is optional not standard. If you don't purchase together with the scope, there will ...

I understand, but I have a LAN module installed on the scope, as shown in the photos that I first included.


Author: timothyle97    Time: 2019-5-11 05:39
Hi, just wondering if there was any update on this. Thanks.

Author: amy    Time: 2019-6-11 09:26
Please open the system information window and take a picture to study.

Author: timothyle97    Time: 2019-6-21 06:09
Hi amy,

I have attached the system information window here. Thanks.
[attach]2966[/attach]


Author: amy    Time: 2019-6-26 09:59
Please send a message to me caiyijun@hantek.com





Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/) Powered by Discuz! X3.2