Title: Shape of 100kHZ sqare wave signal [Print this page] Author: gf1 Time: 2019-4-17 03:24 Title: Shape of 100kHZ sqare wave signal Edited by gf1 at 2019-4-17 03:58
I'm facing the following problem:
When I display a 100 kHZ square wave signal on my 6074BD scope, software 2.2.5, then it does not have a flat top and bottom, but it looks like an overcompensated probe.No probe was used, though, but the signal generator was connected via BNC cable with 50 Ohm feed-through terminator at the scope.
[attach]2792[/attach]
Coupling is DC. All four channels are affected.
The same signal looks OK on my 2D72.
I also tried two different signal generators.
gf1
Author: amy Time: 2019-4-26 14:28
Sir, sorry, this problem cannot be fixed better.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)