I notice new Firmware for the Handhelp 2000 series.My device is a 2D42
update firmware 2021.11.18 --> 2021090901
I follow the instructions as given with the Dfu Upgrade tool
I canot enter Dfu mode the Run /Stop button never start to flash Green and Red , the instruction say I need to reprogram ARM 1 -
can you please assist me with the correct instruction and tools to reprogram the ARM 1 as I would like to run the latest SW Version
Thank you very much
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
Please remove the batteries and install again, can the oscilloscope start normally?
If so, please update the firmware again and take a video for me to study.
Thank you after removing and installing the battries the scope could go into boot mode I upgrade the Firmware to 2021090901 and was very happy to see that
the FW now allows us to select the type of measurement we want to see in the display This is great as it was a limitation in the past
Thank you to HANTEK for this mod