pmaggi replied at 2018-12-10 22:12
With what application do I create arbitrary waveforms and how do they are loaded into the equipment? ...
Good question.
First, you need install the software of Hantek2D42 on your computer.
Power on Hantek2D42 and connect it to your computer by the Type C and USB cabel.
Double click the Hantek2xx2 icon to run the software.
Click the DDS tag on the right side bar.
Click the On/Off option below the DDS tag to enable the waveform generator.
Then select the waveform type as Arb.
Set the Wave Parameters:
a. Frequency: Set the output wave frequency.
b. Amplitude: Set the output wave amplitude.
Use the mouse to draw the waveform on the oscilloscope display window on your computer, and then the arbitrary waveform you drawn display on Hantek2D42 device the same time.
You can download four different waveform to Arb1, Arb2, Arb3, Arb4.
Connect the cable from the output BNC of the waveform generator to a input BNC of the oscilloscope and select the arbitrary waveform you created as the output waveform type, and the device will output it.