I have on model 2D42 all works. To see the oscilloscope signal from the generator, you need to run it by pressing the button it will change from red to green, then if you close the probes and select the Scope function, you can see the signal. The mass during the test can not be connected
Yes I have used the AWG before you can see in the picture the model number
and the firmware model number does not match !!Meter Serial No: CN1848008001214
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
Alan_C replied at 2019-2-26 02:21
Hi
I have a new problem after upgrading the firmware I lost the AWG function meter is being detecte ...
Sir, before update the firmware, have you used the AWG interface to output the signal?
Can you confirm that the model in the system information is 2D72 before you update the firmware?
Hi
I have just updated to the latest firmware, I have 2 issues that are bothering me
1, Why is the Autoranging on DMM, OHM of this multimeter is so SLOW ??
2, would greate if the backlight timeout would reset itself when the meter is being used on DMM ( when input is detected )
Hello. Thank you very much that in the new firmware for February they implemented the function of at least m maximum. The device works better with this firmware.