after flashing Firmware version: 2019082401 sucessfully 4 times, the firmwarenumber in menue sys info on the 2c42 is still the old one "soft: 2019060601"
The same is happening to me... updated with 2019082401 but sys info says 2019060601.
Apart from that, AWG now have a strange behaviour. All wave form apart from the square one show a pulse at the begining of the period.
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
amy replied at 2019-3-12 14:07
If you can use TTL serial port tool, please refer to the attachment to program arm1 and arm2:
http ...
Hello, I don't know if I can understand the Chinese I sent. I would like to ask you, my 2d72 hand-held oscilloscope is not on now, and the DFU mode can't go in. There is no response to disassembling batteries and inserting data lines in F1. How can I do this? I can connect with stlink after I disassemble it. I don't know what's wrong with it. Looking forward to your reply 1 Thank you.
How do I update system files with stlink?
Достали уже, со своими кривыми обновлениями...
Ничего не исправили, что просил, только новых багов наделали. В чём фишка?
Там что реально какие-то ослы работают?
Раз пять нормально спрашивал, просил хоть что-то ответить, сплошной игнор!
Я же не прошу чего-то нереального! Час работы, имея исходники...
Thank you very much, but I can see the file, that is, it can't be registered and logged in, so it can't be downloaded. I also need to ask if you can send it to gonggye863@sohu.com or to the forum for me.