Sasann0074 Publish time 2023-10-3 15:54:05

DSO2D10 oscilloscope does not boot

Hi , i have a Hantek dso 2d10 oscilloscope, i was trying to update its firmware , but oscilloscope breaked while updating and after restarting , stays on the hantek logo and does not go further


smith545 Publish time 2024-1-30 22:50:50

Hi , i have a Hantek dso 2d10 oscilloscope, i was trying to update its firmware toonkor , but oscilloscope breaked while updating and after restarting , stays on the hantek logo and does not go further

kevinmartin Publish time 2024-2-26 15:15:09

First, make sure the power supply is properly connected and working. Check that the power cable is securely plugged into the oscilloscope and the power outlet.

Floor Refinishing Expert in Cape Coral FL

rafaelholeva Publish time 2024-3-9 03:36:45

Give up my friend! hantek technical support is terrible, I had the misfortune of purchasing two hantek products Hantek DSO 2D15 and Hantek 6074BD, both purchased between 2023 and 2024, both stopped working after the update! I've already asked for help via email, on the forum and none of Hantek engineers helped. I've already searched the Forum and nothing, I've searched the website and nothing either, I've never seen a post-purchase support service anywhere in the world, as terrible as the Hantek support service. Anyway, if anyone is reading this post, I do not recommend purchasing Hantek products, if I get the correct technical support, and if my equipment works again, I will come back here and recant.
Pages: [1]
View full version: DSO2D10 oscilloscope does not boot