wangshuang Publish time 2021-12-28 11:31:04

8060 stopped starting

Customer consultation

The oscillograph stopped starting - "Self check" does not pass. That is, after switching on - a short buzzer - 5 seconds of waiting - a click of the relay - switching off. It does not reach the start of the display.


wangshuang Publish time 2021-12-28 11:40:10




Reply
You can measure the voltage at these points in the figure below.




iMaks-RS Publish time 2021-12-28 15:02:37

my board is different

wangshuang Publish time 2021-12-30 14:22:36

iMaks-RS replied at 2021-12-28 15:02
my board is different

Please measure these points in the figure below.

iMaks-RS Publish time 2022-4-4 19:35:15

The voltages at the indicated points and the frequency are the same as those indicated in the figure (photo) 2-1.png. But - are present only after pressing the power button of the oscilloscope. They disappear after 3-5 seconds.
Figure (photo) 2-2.png is different from what I have.. the tantalum capacitor is missing. Tell me on what conclusions to take measurements. I put the voltmeter probe on the test point, the track from which leads to pin 2 of the U26 chip. There 0V.
Pages: [1]
View full version: 8060 stopped starting