ying Publish time 2019-4-17 10:39:09

Shutdown(Sleep) setting

Edited by ying at 2019-4-17 10:45

Customer Consultation

I have a Hantek DSO1202B scope and IM find that, after not pushing any buttons for a while, the scope goes into stand-by (sleep?) mode.I can wake it up by touching any button.Is there a way to tun off the standby (sleep) function? I apologize if I have missed it in the manual. My serial number is DS00504666 and the firmware is 2.01.1 (170908.0).


ying Publish time 2019-4-17 10:43:11

Reply
Please press "Utility->F5" to page to 2/5 and select "Shutdown" to set poweroff time as a long time.Please refer to the following picture.



zkakuszi Publish time 2019-11-27 20:46:02

Hi .. my one is DSO1062B.. and I can set the time .. and confirm, but it is going to switch off in one minute anyhow

At the first sight.. help!!

amy Publish time 2019-12-2 16:46:54

If you cancel the automatic poweroff, what's the result?

ying Publish time 2020-12-22 08:49:19

zkakuszi replied at 2019-11-27 20:46
Hi .. my one is DSO1062B.. and I can set the time .. and confirm, but it is going to switch off in ...

Please try to set the backlight keep time as "Unlimited".
Press "Utility" button and F5 to page 4/5 as the below figure.




Then press F5 to page 3/3 and set the backlight keep time as the below figure.




BurakBey Publish time 2021-2-28 19:09:45

Can we change the backlight duration unlimitedly and create a profile that saves the changes? In order not to need to be adjusted every time
Pages: [1]
View full version: Shutdown(Sleep) setting