|
|
Edited by AxGxP at 2019-12-13 07:00
Fixed firmware avaliable:
My Hantek2c42 often doesn't pass the calibration. It freezes on it! I wait for more then 5 min, nothing changed. Fixed!
A problem also with DMM. In "DC mA" is not zero even when i cross the probes. It always show 0.02-0.05 mA, without probes also. Fixed! (the flux between +battery (J1) and shunt resistor 1 Ohm wasn't washed)
Please make some changes in the new firmware:
0. Add some functionality to export saved oscillograms to PC.
1. Add Menu hide (toggle) on second pressing "Menu", "Trig", "Channel", "Time". (MyFix)(HantekHTXAxGxP0001)
2. In Channel mode change LEFT<->RIGHT buttons, in Time menu UP<->DOWN! (MyFix)(HantekHTXAxGxP0001)
3. Add horizontal scale settings during operation. At least option to see all the signal on the screen but not a part of it! (somesing like 1:1 or 1:10 in analog scopes)
4. Make working icon about channel coupling AC,DC, Gnd. (~,–,x). Fixed! (2019022001)
5. When menu is hidden. Make changing of arrow buttons usage: "F1" - CH1 changing, "F2" - CH2 changing, "F3" - trigger changing, "F4" - time changing. Without showing this menu! Only arrow buttons function changing! (MyFix)(HantekHTXAxGxP0001)
6. Change word "Double" to "Both" in triger edge selection.
7. DMM Buzzer mode. Bug with sound, after shorting it say "Pi-pause-piii" but not single "Piii". Very slow measurement near 8-10 sec before value is stopped. It better to mesure voltage, not resistance.
8. In "Trigger" mode change buttons "<-" and "->" form changing trigger level to changing trigger position, like it does in "Time" menu.
What about adding some new not documented features, for example X-Y mode etc. Can it be possible? Fixed! (X-Y pressent in2019030201) |
|
|
发表于 2018-12-30 02:04:23
楼主
发表于 2019-1-4 10:20:11
