|
|
Edited by Katabоrmot at 2023-12-25 11:20
Hello! When checking the functionality of the HDG2102B generator, several problems were discovered.
All settings of the "Counter" mode are not fully accessible.
When I try to change the "chanel" parameter to "High Freq" nothing happens, the mode remains "Low Freq".
"Trig menu" is not available. When I press the button, nothing happens.
"Trig'd" light does not light up.
There was a time when when entering Freq/Amp/Offset from the digital field, the values were not entered correctly, but this error could not be reproduced again.
Self test:
Testig rtc clock: Failed
Testig front panel processer: Failed
Testig ch1 zoom unit 1: Failed
Testig ch2 zoom unit 1: Failed
Device settings:
Model: HDG2102B
Serial: DDS2300791
Start Num: 13
Update Num: 0
Cpu: Single Core
Memory: 64MB
PCB: 1004.1
Software: 1.00.3.03.05 (150710.0)
Kernel: Linux 3.2.35
FPGA: 41
Keyboard: 3
Does my device have a newer version of Firmware?
Perhaps updating the Firmware will correct some of the errors and make the device more stable?
|
|
发表于 2023-12-25 02:32:51