|
|
楼主 |
发表于 2024-2-19 13:35:35
|
显示全部楼层
Edited by rafaelholeva at 2024-3-5 01:52
Hello Hantek people, upon receiving the File sent, I successfully updated as requested! However, now the equipment's software has stopped responding, when trying to open the hantek6000 version 2.2.7 application on Windows it simply does not open, the application is stuck in the Windows processes and does not appear!
When removing the USB cable, it opens but no longer recognizes the device!
I believe that the FPGA version you sent me is not the same as the one corresponding to the equipment in question! To do this, I will be forwarding a link with photographs of my opened equipment and my request for help and support on the hantek surpote support forum itself.
Link: https://www.eediscuss.com/forum. ... 8587&extra=page%3D1
If possible, I would like you to send me the correct firmware version to update the board via Cypress file (*.iic) so that it can be updated via (RestoreIIC.exe) or (CyConsole.exe).
After also the correct FPGA version for the LemonTree 2090 chip, PCB version DSO6000BCD_V1.00
I hope your help! Thanks!
|
|
发表于 2024-2-9 15:36:55