Update the firmware of Hantek2D72/2D42/2C72/2C42

12345

echarlus replied at 2019-3-29 17:11
Hello,
I've received a new 2D42 yesterday and it was working fine. I've tried to upgrade firmware by ...

https://fil.email/8s7tpIS2

nnnnik

Hi, amy

can you open source code?

may be.. libs.. protocols..

amy

nnnnik replied at 2019-3-30 07:36
Hi, amy

can you open source code?

Sorry, we don't provide open source code.

echarlus

12345 replied at 2019-3-29 23:35
https://fil.email/8s7tpIS2

Hi thanks a lot for the info.
One question regarding the TTL to USB device, should I get one using  3.3V or 5V signals ? I see both model exist ...
Thanks

amy

You should use 3.3V.

Sebastien

amy replied at 2019-3-28 11:28
Method 1:
First turn off the scope and connect the scope to your computer.
Press F1 and power button ...

Both solutions are not working.
As soon as it get some power from USB or battery the scope is starting.
I can see the DFU mode in windows device manager but it stay less than a second and the scope is automaticaly booting.

Any other idea?

wadimk

Why do you need an oscilloscope, if you can not program the CPU ?
https://ru.aliexpress.com/af/st% ... ewCP=y&jump=afs

echarlus

amy replied at 2019-4-2 11:30
You should use 3.3V.

Hello,
I've tried to follow the procedure described in "rogram Arm1" but the Flash Loader demonstrator keeps on saying that there is no response from the target (I see a brief led flashing on the USB to TTL board).
I've checked that I've installed the proper drivers for the USB to serial device and this part seems to be working ok (device is detected, USB port is created).
I did put a jumper between the 2 pins as described and then I plug in the USB cable in the computer.
the Flash loader states "Verify the boot mode configuration" and the flash protection status (see screenshot); I've only set the jumper, is there anything else to do on the scope (hit a combination of keys to start it in the proper mode ? I've tried power+F1 with no success).
Thanks for any advice ... I'm quite stuck here

12345

echarlus replied at 2019-4-6 01:16
Hello,
I've tried to follow the procedure described in "Program Arm1" but the Flash Loader demonst ...

Connect RX to TX and connect TX to RX

echarlus

12345 replied at 2019-4-6 02:11
Connect RX to TX and connect TX to RX

Thanks for the hint (I should have thought of that ...) unfortunately it did not solve my problem. Still the same error from the software (I still have a led flashing briefly on the USB to TTL device and that's it).
Any other hint I could try ?