|
发表于 2019-3-29 17:11:51
|
显示全部楼层
Hello,
I've received a new 2D42 yesterday and it was working fine. I've tried to upgrade firmware by following the instructions found on this forum (using firmware and update tool from this page http://hantek.com/en/ProductDetail_1_13174.html, updating using Windows 10) and the update failed right after the flash was erased (see screenshot).
Now the device is dead and cannot start anymore (not even in DFUse mode ...)
Any way to recover and unbrick it ?
Thanks in advance for your help.
|
|