Hantek DSO-5202B No signal and no buttons

amy

Rogerm replied at 2017-11-17 18:42
Hello:
If you can send me the software, I thank you, I'll try to program it.

Sir, I have sent the software to your email. Please check.

Rogerm

Thank you.
I have already received the file as soon as the EPM240T100C5 chip arrives and I got it programmed and welded it to him.

A greeting.

Rogerm

Hello:
I have already changed the EPM240T100C5 and programmed and continue doing the same.

Rogerm

Can it be the FPGA EP3C5F256C8N? I think this is the chip that carries.
Do you have the file?
To try.
Thank you

amy

Rogerm replied at 2017-11-22 03:40
Can it be the FPGA EP3C5F256C8N? I think this is the chip that carries.
Do you have the file?
To try ...

Sir, are you sure the software of EPM240T100C5 is programmed successfully?
Please give us a video of current fault phenomena.

Rogerm

Rogerm

The video is: https://youtu.be/2Bd0qEY6vcc
It does the same as always.

amy

Rogerm replied at 2017-11-22 11:41
The video is: https://youtu.be/2Bd0qEY6vcc
It does the same as always.

Sir, the video was released for a long time. There are some bugs inside, not your problem.
I can't understand your problem clearly.
Please give me the video fo your scope.

Rogerm

Hello:
the video was Posted on Nov 21 2017 when you told me.

You can check that it's in my name.
It's from my oscilloscope.
If you want, I send the video to some place.
I could pass the file of fpga to try, if not already I leave it without repair.
And I buy another one.
Thank you for your patience

Rogerm

I put in the title of the video: fault oscilloscope Hantek Dso-5202b for Amy.
So you can see what mine is.
The video is: https://youtu.be/2Bd0qEY6vcc
you can check wherever a video like mine does not exist it's my original



The problem is:
As you turn it on it stays the same as in the video, it does not do anything as it is blocked.